Question:
Are the HOCL-1 and HOCL-45 angle clips ICC listed like other brands?
Answer:
California Division of the State Architect (DSA) compliance has been found to be sufficient for stand-alone angle clips. Both the HOCL-1 and the HOCL-45 comply with California DSA. See page 22 of DSA IR 25-2.13 – Appendix A below.
Please note ½” max from center to edge, and ½” TYP (typical) from bottom edge to wire tying hole for #12 gauge wire.
We have not been able to find a stand-alone angle clip that is ICC listed. As far as we can tell, the ICC listings that have been published by other brands apply to their pin and clip assemblies, not to the angle clip by itself.
For example, Ramset part #: 1202CF is not shown anywhere on their ICC report located here: https://www.icc-es.org/wp-content/uploads/report-directory/ESR-1799.pdf
It only lists the “SP” & “SPC” part numbers for the assemblies as is shown in the image below.


DEWALT/POWERS ICC REPORT:
https://www.icc-es.org/wp-content/uploads/report-directory/ESR-2024.pdf
HILTI TECHNICAL DATA GUIDE: