I-Wedge Tool

Use the SDS PLUS I-Wedge Installation Tool to install I-Pins, Eye-Wedge Anchors and Powers’ Tie-Wire Spike Anchors using the “hammer only” feature of an SDS Plus hammer drill.

Attaches to any SDS Plus Hammer Drill
Weighs .40 lbs.

Product Code: I-Wedge

VIDEOS

INSTRUCTIONS

1/4″ I-Pin Anchor Installation Instructions

Required tools and fasteners: ODM, ODM-250, ODM I-Wedge, ODM-IP

Step 1. Drill a 1/4″ hole in the concrete ceiling using an ODM (Overhead Drill Machine) and an ODM-250 1/4″ x 1.25” HALT BIT.

Step 2. Remove the ODM-250 HALT bit and insert an ODM I-Wedge SDS Plus installation tool into your hammer drill, set the hammer drill to hammer only.

Step 3. Insert a pre-tied ODM-IP 1/4″ I-Pin anchor into the slot of the ODM I-Wedge installation tool and hammer the anchor into the hole.

Step 4. Pull down to set the anchor.

I-WEDGE Installation Tool Instructions